Door and Window Weatherstrip Seals | OEM Replacement Parts
1 subcategory — 34 SKUs
Door and window weatherstrip seals prevent air infiltration and water intrusion at frame perimeters. Stock 34 OEM-compatible weatherstrip profiles for hinged doors, sliding glass units, and window frames across residential and light commercial applications.
Pile / Fuzzy Weatherstrip for Windows
Weatherstrip .187" backing x .156" pile height - Gray
Weatherstrip .250" Backing x .200" Pile height - Gray
Weatherstrip .200 backing x .156 pile height, Grey
Check Rail Adhesive Back Weatherstrip, 3/8 x 1-1/16" w/ Fin Seal
Adhesive Back Weatherstrip .270 x .200 Pile - Sold by the Foot
Adhesive Back Surface-Mount Weatherstrip .187" x .270" Pile with Fin Seal
Adhesive Back Weatherstrip .250 Backing x .150 Pile
Adhesive Back Surface-Mount Weatherstrip .270" x .300" Pile
Adhesive Back Weatherstrip .500 Backing, .270 Pile Height
Weatherstrip .187 backing x .140 pile height - Grey
Weatherstrip .360 backing x .450 T-Slot pile, Fin, Z-back - Gray
Weatherstrip .430 backing x .350 T-Slot pile, Fin, Z-back 100' Roll -Gray
Weatherstrip .430 backing x .450 T-Slot pile, Fin, Z-back - Grey
Weatherstrip .187 backing x .180 pile height - Grey
Weatherstrip .187 T-Backing x .210 Fuzzy Pile
Fuzzy Weatherstrip .187 Backing x .220 Pile w/ Fin seal
Fuzzy Weatherstrip .187 T-Backing x .250 Pile with Fin Seal
Fuzzy Weatherstrip .187 T-backing x .270 Fuzzy Pile
Fuzzy weatherstrip .187 T-Back x .270 pile, with Fin Seal
T-Back Pile Weather Strip Tri Fin .187 / .270
Weatherstrip .187 T-Backing x .280 Fuzzy Pile
Weatherstrip .187 backing x .300 pile, T-Slot Fin Seal - White
Weatherstrip - .187 T-Backing x .310 Fuzzy Pile, with Fin Seal
Weatherstrip .187" T-Backing x .350" Fuzzy Pile
Weatherstrip Selection by Door Type and Frame Configuration
Weatherstrip degradation causes thermal loss, moisture penetration, and air leakage—critical failure points in door and window assemblies. Correct profile identification requires frame depth, material compatibility (vinyl, rubber, silicone), and compression set specifications. Replace worn seals during retrofit, new construction, or maintenance cycles to restore thermal and acoustic performance.
Identify the Right Profile for Your Frame Assembly
Weatherstrip sits in grooves or adheres to frame edges to seal gaps between sash/door panel and frame. Measure frame width, depth, and compression distance; verify OEM part number against your door brand and model. Profile geometry—U-channel, bulb, or pile configurations—must match original specifications for proper seal and operational clearance.
Sizing and Material Specifications
Weatherstrip durability depends on material grade (vinyl vs. silicone), compression set rating, and UV/temperature range. Common widths range 1/2" to 1" with varying depths for frame cavity fit. Verify lengths required per frame (top, sides, bottom runs differ); order slightly over measured length to avoid field cuts that compromise seal integrity.
Trade Volume and Technical Support Resources
Contractors and glaziers order full frame sets or individual runs for retrofit work. All About Doors stocks OEM cross-references and application guides for major manufacturers. Technical specs available for compatibility verification and installation best practices.